Low

FTDI  FT234XD-R  Interface Bridges, USB to UART, 2.97 V, 5.5 V, DFN, 12 Pins, -40 °C

FTDI FT234XD-R
Technical Data Sheet (765.00KB) EN Bekijk alle technische documenten

De afbeelding is alleen ter illustratie. Zie de productbeschrijving.

Productoverzicht

The FT234XD-R is an USB2.0 Full Speed IC, offers a basic UART to USB bridge. The device is an UART, capable of operating up to 3Mbaud, with low power consumption (8mA). The FT234XD-R includes the complete FT-X series feature set, including battery charging detection and enables USB to be added into a system design quickly and easily over a UART interface.
  • Single Chip USB to Asynchronous Serial Data Transfer Interface
  • Entire USB Protocol Handled on Chip, No USB Specific Firmware Programming Required
  • Fully Integrated 2048-byte EEPROM for Storing Device Descriptors and CBUS I/O Configuration
  • Fully Integrated Clock Generation with no external crystal required + Optional clock o/p selection
  • Data Transfer Rates from 300 Baud to 3Mbaud
  • 512-byte Transmit and Receive Buffer utilising buffer smoothing technology for high data throughput
  • Royalty-free VCP and Direct (D2XX) drivers eliminate requirement for USB driver development
  • Configurable CBUS I/O Pins
  • Transmit and Receive LED Drive Signals
  • UART Interface Support for 7 or 8 Data Bits, 1 or 2 Stop Bits and Odd/Even/Mark/Space/No Parity
  • Synchronous and Asynchronous Bit Bang Interface Options with RD# and WR# Strobes
  • Battery Charger Detection, presence of a charger on USB port to enable faster charging of Batteries
  • Device Supplied Pre-programmed with Unique USB Serial Number
  • Supports Bus Powered, Self-powered and High-power Bus Powered USB Configurations
  • Integrated +3.3V Level Converter for USB I/O
  • True 3.3V CMOS drive output and TTL input (Operates down to 1V8 with external pull up)
  • Configurable I/O Pin Output Drive Strength
  • Integrated Power-on-reset Circuit
  • UART Signal Inversion Option
  • Internal 3.3/1.8V LDO Regulators
Absolute maximum ratings for devices are as mentioned, accordance with the Absolute Maximum Rating System (IEC 60134), exceeding these may cause permanent damage to the device.

Productgegevens

Bridge Type:
USB to UART
Supply Voltage Min:
2.97V
Supply Voltage Max:
5.5V
Interface Case Style:
DFN
No. of Pins:
12Pins
Operating Temperature Min:
-40°C
Operating Temperature Max:
85°C
Packaging:
Cut Tape
Product Range:
-
Automotive Qualification Standard:
-
MSL:
MSL 3 - 168 hours
SVHC:
No SVHC (17-Dec-2015)

Zoeken naar vergelijkbare producten  per overeenkomende kenmerken

Toepassingen

  • Signal Processing;
  • Computers & Computer Peripherals;
  • Communications & Networking;
  • Consumer Electronics;
  • Sensing & Instrumentation;
  • Industrial;
  • Power Management

Wetgeving en milieu

MSL-niveau voor vochtgevoeligheid:
MSL 3 - 168 hours
Land van oorsprong:
Taiwan

Land waarin het laatste noemenswaardige fabricageproces is uitgevoerd

RoHS-compliantie:
Ja
Tariefnummer:
85423990
Gewicht (kg):
.0001

Gekoppelde producten

Vergelijkbare producten

Zoek producten die qua functionaliteit lijken op dit product. Selecteer een van de volgende koppelingen, waarna u naar een productgroeppagina gaat met alle producten in deze categorie die het vermelde kenmerk delen.